Ticket #12 - Republished
20/06/10 20:45
I am reposting here Lab 12, which was published on ccieflyer.com. Next ticket, Ticket 13, which will be about BGP, will be published on CCIEFlyer.com, then it will be republished here again. And so on for the next few Tickets.
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
For the solution Click here
For more mini labs, have a look at the mini labs page.
Also have a look at the complete troubleshooting workbook.
Network diagram
IGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R3, R1 and R5 can't ping R2's Lo0 IP address. Fix the problem without touching R1.For the solution Click here
For more mini labs, have a look at the mini labs page.
Also have a look at the complete troubleshooting workbook.
Ticket #12
19/05/10 16:02
Ticket #11
15/04/10 20:49
Network diagram
IGP diagram
BGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R1 can’t ping R2’s Lo0 IP address. Fix the problemFor the solution Click here
For more mini labs, have a look at the mini labs page.
Also have a look at the complete troubleshooting workbook.
Ticket #10
22/02/10 14:47
Network diagram
IGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R6 was configured to summarize R3's Lo30,Lo31,Lo32 and Lo33, so R4 would see only one summarized route for them.However, R4 still sees all the routes.
Fix the problem while, making sure R6 sees all R3's routes.
For the solution Click here
Ticket #06
25/12/09 22:49
Network diagram
IGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R2 can't ping both R1's Lo11 and R4's Lo44 at the same time from all its interface. Fix the problemFor the solution Click here
Ticket #05
12/12/09 21:47
Network diagram
IGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R4 can't ping R5's Lo0 IP address. Fix the problem using OSPF commands.For the solution Click here
Ticket #02
05/11/09 18:40
Network diagram
IGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
While R3 can ping R1's Lo0 IP address, R4 can't do so. Fix the problemFor the solution Click here
Ticket #01
28/10/09 21:10
Network diagram
IGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R1 can’t ping R3’s Lo0 IP address. Fix the problem.For the solution Click here